Call Us

Epoxy Coal Tar Finish Paint

Epoxy Coal Tar Finish Paint

Product Details:

  • Usage Protective Coatings
  • Physical Form Liquid
  • Supply Ability : 10000 Liter Per Month
350.00 - 450.00 INR/Liter
X

Price And Quantity

  • 350.00 - 450.00 INR/Liter
  • 20 Liter

Product Specifications

  • Liquid
  • Protective Coatings

Trade Information

  • Kolkata
  • Telegraphic Transfer (T/T), Cheque, Cash in Advance (CID), Cash Advance (CA)
  • 10000 Liter Per Month
  • 1 Week
  • Yes
  • Contact us for information regarding our sample policy
  • As Per Buyers Requirement & Order
  • All India
  • ISO 9001:2008

Product Description

Epoxy Coal Tar Finish Paint is a two pack protective coating which is produced by combining the reinforced composition coal-tar with epoxy in addition with a number of suitable additives. It is especially synthesized with best grade chemicals and due to its excellent resistance against water it is considered as an ideal solution for the protection of sluice gates of hydro electrical projects, barrier gates of irrigation projects and underwater structure of bridges sea shore where continuous water immersion occurs. The flash point of the Epoxy Coal Tar Finish Paint is approximately equals and less than 28 degree Celsius. 

Two component, air drying, high build epoxy coal tar finish coating confirming to IS 14948: 2001

Features

  • Good resistance to corrosion in marine exposure and subsoil conditions
  • Outstanding water resistance
  • Good abrasion resistance
  • Good chemical resistance

Technical Specifications


Color

Black/Brown.

Gloss

Semi glossy to Eggshell.

Volume Solids

Approx. 55 to 60 %.

Recommended DFT / coat

 100 – 125 mµ.

Theoretical covering capacity

 4 to 6 m2/l @ 100 microns

Curing time at 30°C

Surface dry : 4 hour

Hard dry : 24 hours

Full cure : 7 days

Shelf life (cool & dry place)

 24 hours (min).

Flash point

Base : < 28°C



Surface Preparation & Substrate Condition

  • Surface must be free from rust, loose scale, mill scale, best result can be attained by sand blasting to Sa 2½, or power tool cleaning at St 3.
  • Surface temperature must be at least 3°C above dew point but not above 50°C.

Mixing:

Stir the base and hardener separately to get an uniform mix, then add hardener slowly to the base slowly with constant stirring for quick homogenous mixing.

  • Mixing ratio : Base : Hardener :: 4 :1(v/v)
  • Induction time : 30 minutes
  • Pot life at 30°C : 8 hours

Application:

Brush

Recommended thinner

WP Thinner No. 8

Volume of thinner

0 - 10 %

Air spray

Recommended thinner

WP Thinner No. 8

Volume of thinner

5 - 20 %

Nozzle orifice

1.5 - 3.0 mm

Nozzle pressure

0.3 - 0.4 MPas

Airless spray

Recommended thinner

WP Thinner No. 8

Volume of thinner

0 - 15 %

Nozzle orifice

0.41 - 0.48 mm

Nozzle pressure

20 - 24 MPas



WASSER POLYMER PVT LTD

* Tips on getting accurate quotes. Please include product name, order quantity, usage, special requests if any in your inquiry.



Back to top
WASSER POLYMER PVT. LTD. All Rights Reserved.(Terms of Use)
Developed and Managed by Infocom Network Ltd.